Graph-tech Ghost Manuel d'utilisateur télécharger pdf (Page 39)

In most cases, no enlargement of the cavity is required to install

the main Hexpander board. Guitars with small cavities like

Telecasters, or guitars with a lot of electronics already installed

may require some routing to make room for the Hexpander.

Enlarging the control cavity

The jack plate can easily be curved to conform to the surface of the

edge of the instrument where the 13-pin jack is to be mounted.

An even curve can be achieved by placing the jack plate face up on

hard surface with a sharp

edge (anvil or machinist’s

vice is ideal) and moving

the jack plate progressively

over the edge while

tapping the jack plate

against the edge with a

soft-face mallet. The edge

will make lines on the

back of the jack plate, but

the face will be smooth.

Curving the Jack Plate

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 75 76

Pas de commentaire

Graph-tech Ghost Manuel d'utilisateur Page 39