Graph-tech Ghost Manuel d'utilisateur télécharger pdf (Page 38)

Using a router, a Dremel rotary tool, or a chisel, remove the

remaining wood to edges of the marked rectangle, to a

depth of 1-1/8”. Be careful not to enlarge the mounting hole

beyond the lines, as the jack plate ts quite precisely to these

dimensions. Remember, this cavity does not have to be neat

and smooth, as it will be hidden completely by the jack plate.

Drill through the back of this cavity to join it to the main control

cavity where the Hexpander will be located. Two 5/16” holes side by

side makes a slot wide enough for the ribbon cable to t through.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 75 76

Pas de commentaire

Graph-tech Ghost Manuel d'utilisateur Page 38