Graph-tech Ghost Manuel d'utilisateur télécharger pdf (Page 46)

After the mounting hole has been routed and the 13-pin jack

plate has been curved to conform to the edge of the guitar

(see instructions in the Routing, Drilling, and Notching section

of this manual) bolt the 13-pin jack plate to the 13-pin jack

using the supplied nuts, bolts, and lock washers. Be careful to

align the Traktion switch with the slot in the 13-pin jack plate;

tightening the bolts with this slot misaligned will damage the

Traktion switch and may make the Hexpander unusable. When

tightening the bolts, make an eort to center the 13-pin jack

in the round hole in the 13-pin jack plate. Perfect centering is

not necessary, but severe misalignment will prevent the 13-

pin plug from seating properly and making a good connection.

13-pin jack

Align the 13-pin jack plate with the four screw holes drilled in the

guitar body. Make sure that the 13-pin jack is oriented the same way

as planned when making the mounting hole, as it is not symmetrical

and cannot be reversed 180 degrees. Attach the 13-pin jack plate

to the guitar body using the four small wood screws supplied.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 75 76

Pas de commentaire

Graph-tech Ghost Manuel d'utilisateur Page 46